evoVIU Manual
-
Introduction
-
General & Safety
-
Hardware
-
Software
-
Einleitung
-
Allgemeines & Sicherheit
-
Hardware
-
Software
< Alle Themen
This chapter describes the two types of mounting.
Notes
The camera may only be set up by a mechanically skilled person.
WARNING
Note the proper installation of the camera. If the camera is suspended in an area where there is pedestrian traffic, the camera must be secured from falling with a wire attached to a screw on the back plate with an attachment point on the outside.
1. -S: Side-Mounting
For side mounting, the camera requires 2 M6 x 16 screws. The distance here is 38mm.
![evoVIU side docker](https://www.evoviu.de/wp-content/uploads/2022/04/docker_side-1024x576.png)
2. -T: Top Mounting
For top mounting, the camera requires 4 M3 x 16 screws. The distance is 38.5mm on the short side and 58.5mm on the long side.
![evoVIU Top Docker](https://www.evoviu.de/wp-content/uploads/2022/04/docker_top-1024x576.png)
Übersicht